Cleaning The Robotic Mower In 7 Easy Steps

Your robotic lawnmower takes over the tedious lawn care for you completely autonomously. It’s time to give it something back for its efforts and clean it from the ground up. But be careful! Because with a garden hose you are definitely out of place with the sensitive robot. Instead, cleaning the robotic lawnmower requires sensitivity, a little water and even less cleaning agent.

How do you clean the robotic lawnmower? Step-by-step to a clean robotic lawnmower

Cleaning the robotic lawnmower Step 1 – Preparing for cleaning

Before starting the actual cleaning, it is important to ensure sufficient safety. Almost all models have a safety switch. Be sure to set this to “off” before you start cleaning.

Safety gloves further reduce the risk of injury from the sharp blades. Also, make sure that the device is completely dry before cleaning.

Also important! A robotic mower is an electrical device. Under no circumstances should the electrical components be cleaned under running water or with a garden hose.

Cleaning the robotic lawnmower Step 2 – Cleaning the body

On many robotic mowers, the body is removable. To do this, loosen the ball heads or screws and the charging connection cable. The end of the charging cable is usually fixed with a clamp and thus cannot slip into the robot.

Now you can clean the body with a damp cloth and then dry it. If you dare, you can also remove the wheels. Then these can be greased or replaced if necessary.

Cleaning the robotic lawnmower Step 3 – Removing grass clippings

You can easily remove grass residues between the wheels by hand or with the help of a branch. Before doing so, make sure that the safety switch is set to “OFF”.

Cleaning the robotic lawnmower Step 4 – Cleaning the charging contacts

To ensure that the robotic lawnmower battery charges optimally, regular cleaning of the charging contacts is essential. Otherwise the battery will charge much more slowly or even not at all.

The charging contacts must never be cleaned under running water. Even a wet cloth is unsuitable for this sensitive part. Better. A slightly damp cloth with which you gently run over the contacts.

Cleaning the robotic lawnmower Step 5 – Cleaning the sensors

Just like the charging contacts, you must also clean the sensors regularly. This is because the robot uses them to orient itself in the garden. Dirty sensors affect the performance and efficiency of the robotic lawnmower.

Here, too, a slightly damp cloth is the method of choice. In case of heavy soiling, you can use a drop of dishwashing liquid.

Cleaning the robotic lawnmower Step 6 – Sharpening the cutting blades

To ensure that the robotic lawnmower cuts grass precisely, the cutting blades must be sharpened regularly. This is because small stones, branches or other things lying on the lawn cause the blades to dull.

There are two ways to do this – either sharpen the blades or replace them. Replacement blades are relatively inexpensive. If you still want to sharpen the blades, be sure to follow the manufacturer’s instructions. Otherwise you risk injury.

Cleaning the robotic lawnmower Step 7 – Check the service plug

In the course of the cleaning work, you should finally take a look at the service plug. It must be free of dirt or water.

FAQ

How often should I clean my robotic lawnmower?

The more frequently and intensively a robotic lawnmower is used, the more often it must be cleaned. You should remove grass residues after each pass. A generous cleaning every one to three months is sufficient.